BuildToolsHub US Construction Calculators

Roofing

Roof Drip Edge Estimator

Estimate drip edge linear feet for eaves and rakes.

Loading tool…

Educational US estimate only. Not engineering, structural, code, or professional construction advice. Mix designs, codes, and local conditions vary — verify with licensed professionals and your building department.

Estimator methodology

BuildToolsHub takeoffs separate net measured quantities from ordered quantities. Ordered qty = net × condition-based waste, then rounded for plant or package sizes (e.g. ready-mix to the nearest 0.5 yd³).

  • Concrete bags: Quikrete / SAKRETE published yields (80 lb ≈ 0.60 ft³). Ready-mix contingencies follow ASTM C94 purchaser practice.
  • Rebar: CRSI published lb/ft tables; optional lap allowance ≈ 40× bar diameter (confirm with drawings).
  • Roofing: NRCA squares (100 ft²); pitch factor √(1+(rise/12)²); ~3 bundles/square for standard shingles.
  • Aggregates / fill: ASTM C29-style densities; swell/compaction allowances for haul and place volumes.
  • Masonry: BIA / NCMA common unit factors (e.g. ~1.125 CMU/ft² for 8×16 face).

Use the Order tab for a supplier call sheet and the Assumptions panel for the exact factors applied to this run.

Why use Roof Drip Edge Estimator

Sum eave and rake lengths to estimate drip edge metal needed, with overlap waste.

Profiles and gauges vary—order the specified profile, not just length.

How to use

  1. Enter job dimensions. Pick a pour/layout condition to set industry waste %, or choose Custom.
  2. Review Net vs Order on the Summary tab — order the rounded quantity, not net alone.
  3. Open the Order tab for a supplier checklist, then print, export CSV, or share the link.

Related searches

  • drip edge
  • roof edge trim
  • eave trim calculator
  • rake edge
  • roof drip edge estimator
  • free roof drip edge estimator
  • online roof drip edge estimator
  • buildtoolshub construction calculator

About Roof Drip Edge Estimator

Do eaves and rakes both need drip edge?

Often yes; some regions use different trim at rakes—follow local practice.

How much overlap?

Joints typically lap a few inches; add a small waste percentage.

Include valleys?

Valleys usually use valley metal, not drip edge—calculate separately.

Is this professional engineering advice?

No. Educational estimates only. Verify with a licensed professional and local codes.

Related tools